This project is read-only.

Attribute Table select the 1st feature

Apr 1, 2015 at 1:41 PM
When I select several features of the same layer in the map, if then I open the Attribute Table Editor window of that layer: my selection is cleared and the first feature listed in the Attribute Table Editor grid is selected in the map.
Is it a normal behavior?

Apr 13, 2015 at 1:39 PM
any news on this subject?
Has someone the same problem?
Best regards
Apr 13, 2015 at 3:50 PM
Hey Fabien,

this is currently the default behavior of the Attribute Table Editor. I had problems with that too and wanted to change it but decided to write my own Attribute Table Editor in the end because I needed to change a lot of other things too.
Apr 13, 2015 at 4:00 PM
Hi jany,
thanks for your answer, I think we will also write our own Attribute Table Editor
Thanks again!